Cisco Access point/Switch swap primary boot image/backup boot image

Last Updated on

Keywords: Cisco Boot Image, Cisco access point, access point, primary boot image, backup boot image, ap running image, cisco mobility express, switch primary boot image, switch backup boot image, swap primary boot image, swap backup boot image

(Click here to read: Cisco Mobility Express – Use web GUI to switch Primary image/Backup image)

1 Connect to the device via console/SSH (If using Mobility express, connect to the device IP via SSH or console cable, not the Mobility Express controller IP address)

2 Login with correct credential

3 You will see “name of the device> ” in command window

Console command window
Console command window

4 Type “show version” to view current image information

Console command - show version
Console command – show version

5 From following image we can see currently the AP us running on “Primary Boot Image” which is “8.8.120.0” the “Backup Boot Image” is “8.10.105.0”

AP Running Image, Primary Boot Image, Backup Boot Image
AP Running Image, Primary Boot Image, Backup Boot Image

6 Now we need to login to “Cisco Controller”. For Mobility Express running as master or “Autonomous Mode” you can SSH to the IP address which you used to login to Mobility Express controller (See following image).

Cisco Mobility Express Controller
Cisco Mobility Express Controller
SSH -> Cisco Mobility Express
SSH -> Cisco Mobility Express

7 Enter following command, replce <AP_Name> with correct access point name

(Cisco Controller) >config ap image swap <AP_Name>
config ap image swap <AP_Name>
config ap image swap MyAP
config ap image swap MyAP

8 If there is no error message returned, reboot the AP.

After the AP rebooted, use the same “show version” command to check the booted image, now it should be swapped. (Or use Wireless LAN Controller Web UI to check current version number)

Leave a Reply

Your email address will not be published. Required fields are marked *